While working with your lawn mower, you may notice that the product is hard to push. This may be due to several reasons.
Set the cutting height to the correct position
One of the reasons for the lawn mower being hard to push is a low cutting height. In this case, the housing or the cutting blade is dragged through heavy grass.
CAUTION: Never attempt to set the cutting height while the product is running.
How to set the cutting height
CAUTION: Do not set the cutting height too low. The blades can hit the ground if the surface of the lawn is not level.
The cutting height can be adjusted in multiple levels.
Move the cutting height lever to increase or decrease the cutting height. Check that you have the correct cutting height for your grass, max 1/3 of the height.
Depending on the model of your lawn mower, the cutting height lever design can vary:
![](https://p3.aprimocdn.net/husqvarna/09939771-6804-4974-87a6-ab2200ca3202/H320-0427_HighResPng.png?optimize=low&format=jpg&auto=webp&height=360&width= 271&fit=bounds)
![](https://p3.aprimocdn.net/husqvarna/e78a577e-0915-4b0c-9df5-af5600b8fef3/GB-645140_HighResPng.png?optimize=low&format=jpg&auto=webp&height=360&width= 270&fit=bounds)
![](https://p3.aprimocdn.net/husqvarna/b9085736-aaae-484b-96bd-ab26009ae588/H320-0834_HighResPng.png?optimize=low&format=jpg&auto=webp&height=360&width= 271&fit=bounds)
Empty the grass collector
The added weight from the cut grass makes the lawn mower harder to push. Empty the grass collector to lower the weight.
Check for blockage
One of the reasons for your lawn mower being hard to push is that there is debris, grass, or branches stuck under the product.
Stop the lawn mower and clean under it.
Clean the drive wheel area
Cut grass and debris could be stuck in the drive wheel area.
Make sure the wheel area is clean by getting rid of the cut grass and debris with a brush and a rag.
Adjust the handle height
Your lawn mower is easier to push if the handle height is set to a level that works for you.
Use the drive on the wheels
Before you pull the product reward, disengage the drive and push the product approximately 10 cm.